BEST ACCESS SYSTEMS 35HW Servisní příručka stáhnout pdf (Strana 100)

Service and Maintenance for Mortise Locks

4–46 W Series Service Manual

Note: The flat side of the outside hub should be opposite the pivot

point on the RQE switch, as shown in Figure 4.44.

Task E. To turn over the cylinder clamp plate:

If the lock is single-keyed, turn over the cylinder clamp plate and insert

it in the case. See Figure 4.43.

Note: The screw must be on the same side of the lock case as the

mortise cylinder.

Task F. To turn over the auxiliary bolt:

1. Remove the auxiliary bolt spring.

2. Remove the auxiliary bolt from the case and turn it over.

3. Insert the auxiliary bolt into the case. The angled portion of the bolt

should be pushed through the front of the case and the feet should

be resting in the slot.

4. Place the long, straight end of the auxiliary bolt spring into the hole

on the auxiliary bolt. The center of the spring coil should rest

around the screw post.

Figure 4.44 RQE switch and hub orientation (closeup)

Pivot point on the RQE switch

Flat side of the outside hub

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 227 228

Žádné komentáře

BEST ACCESS SYSTEMS 35HW Servisní příručka Strana 100