BEST ACCESS SYSTEMS 35HW Servisní příručka stáhnout pdf (Strana 104)

Service and Maintenance for Mortise Locks

4–50 W Series Service Manual

REVERSING THE SOLENOID WHEN CHANGING THE FUNCTION

To change an electrically-locked function mortise lock to the

corresponding electrically-unlocked function, or to change an

electrically-unlocked function to the corresponding electrically-locked

function, you must flip the solenoid.

To flip the solenoid for mortise locks, perform the following steps.

1. Remove the mortise case. See Removing components for IDH Max

Mortise Locks on page 4–3 or Removing components for electrified

mortise locks on page 4–26.

2. Remove the mortise case cover and spacer. See Task A. To remove

the mortise case cover and case spacer: on page 4–43.

3. Grasp the locking bar and rotate it. The solenoid plunger rotates

with it.

4. Remove the locking bar from the solenoid pin.

5. Flip the solenoid and insert the pin of the solenoid plunger into the

hole on the locking bar.

Note: For IDH Max Locks, the solenoid rests in an opening in the

case and is held in place by the case cover. For electrified locks, the

solenoid has two feet that fit into two small holes in the case. When

the feet are inserted properly, the solenoid is held in position.

6. Rotate the solenoid and locking bar into place. See Figure 4.49.

7. Make sure that the solenoid wires or cable is not pinched.

8. Reinstall the mortise case cover and case spacer. See Task H. To

reinstall the mortise case cover and case spacer: on page 4–48.

9. Reinstall the mortise case. See Reinstalling components for

IDH Max Mortise Locks on page 4–13 or Reinstalling components

for electrified mortise locks on page 4–32.

Figure 4.49 Reversing the solenoid (IDH Max shown)

Solenoid pin

Locking bar

Solenoid

plunger

Electrically-locked assembly Electrically-unlocked assembly

Solenoid

cable

Bottom-right

corner of the case

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 227 228

Žádné komentáře

BEST ACCESS SYSTEMS 35HW Servisní příručka Strana 104